It’s the new material I’m working with lately. Instead of cutting and bending thick, hard wire and soldering, I just carve it out of a block of modelling wax and then send it to the casting company. It saves me money because I don’t have to buy precious metal in advance. Wax is a lot less dear should I make a mistake.
I’m currently making rings for myself, while I figure out the intricacies of carving, casting, setting and finishing. I wouldn’t want to sell products before I was ready, would I? 😀
Here are some behind the scenes photos:
The left one is actually my wedding ring! (it will be a little larger in size than I should make it, but I’ll be wearing it on my right hand)
This ring is still in the works. I modified it since this photo session. It will hold the Old European Cut stone also shown.
Here I am trying them on. My finger size is a bit smaller than the pre-drilled holes that wax ring tubes come in, so I don’t even need to enlarge the hole. For some designs, I may need to carve the ring from a solid block of wax instead of using ring tubes.
Purple wax is my favourite, and not only because of the colour! 😉 I find that it doesn’t clog up my bench files and isn’t gummy in texture. I have used blue wax which is softer than purple, and I don’t like it as much. BUT pink wax is the WORST ever. Being a novice, I tried to carve the gummy wax with my wax file and it clogged up to the point where I had to dig out the wax bit by bit with a piece of copper, since using a metal brush didn’t work. Don’t make that mistake, because it will take you an hour to fix up the mess.
More updates on my projects soon to come.