I now have a Flickr Pro account! I can now blog faster and embed my photos so I won’t have to upload them. Hah. I should have done this a lot earlier.


Project 2: Russian wedding ring. So, the rings come from wire. The wire has a D profile shape. They are cut into the right lengths, then bent up and the two ends must face each other flat. This makes the ring an odd shape, but not to worry. After soldering the joints, the rings are hammered on a mandrel to make them round. Then two of the rings are cut open again, so they can be interlocked and re-soldered. Once that’s done, the rings are cleaned up by hand.


Left image shows the ring, hand sanded to remove nicks and blemishes. I have also sandblasted one of the rings to give it a texture. The right image shows the ring complete, after being polished in the vibratory tumbler for about 2 hours. It looks so flawless. Only I know where the flaws are! lol.


So shiny! Fits great, but I must admit that I wanted it just a tiny bit larger, to fit on my right hand ring finger during summer. Next time, I’ll add 1mm to the wire lengths. Rings are very sensitive and my measuring was not perfect.