Blythe pull rings

I made my own pull rings! 131/366
My very first project using the lost wax casting technique. I thought it would be a sweet idea to make little pull rings for these collector’s dolls.

Blythe pull rings, cast and ready for finishing
This was how I got them back. Actually cost a bomb each ($9.50), mainly for the casting service fee. I ordered the two rings in bronze and the teardrop in brass.

Would anyone be interested
These were hand-carved, cast and then hand-finished to a shine.
The Blythe/Twiggy inspired pull rings have a bevelled edge.
I can get these cast in brass or sterling silver (much dearer in cost). If no one’s interested, I might just give up on this. It’s not very economical unless I order more than 10 at once… but there is a very nice weight to them and they’re so pretty!

Large bevelled pull ring 7.8 grams (bronze)
Small bevelled pull ring 5.8 grams (bronze)
Teardrop 9.1 grams (brass)
I suspect brass is a tad bit heavier and denser than bronze.

Bronze equals disaster
I didn’t realise Bronze tarnishes in minutes when it touches water! The first time it happened, I had it tumbled for hardness, rinsed off and I left it to dry naturally. Came back 20 minutes later and it had green spots that were impossible to come off. Back to the polishing lathe… Second go, I needed to remove the soot left by the lathe, so I popped it into my ultrasonic. After 5 minutes, I picked them out and they were like this. I give up! I’m never making anything in bronze again.

Brass and bronze comparison
Brass and bronze come very close in colour, with brass just a bit more yellow and bronze is covered in patches of red tarnish. I had high hopes for that metal.

We’ll see if any one is interested, otherwise I’ll just make them only for myself.
You can register your interest by contacting me (see sidebar).